DIVERSION VALVES

Diversion valves direct flow between the stormwater and the sewer (trade waste) systems. They are used on sites with outdoor wash-down areas such as truck washes, car washes, machinery wash bays, bin washing areas and marinas. 

When it’s dry or raining, the valve sends clean rainwater to stormwater. When someone starts washing down, the valve switches to send the dirty water to the sewer (or to a treatment system like an oil and grit chamber) instead. When the washing finishes, it switches back. If it doesn’t, you either flood the sewer with rainwater or send dirty water to the stream.

Diversion valves are sensor-driven. They use flow switches, rain sensors, solenoids, hydraulic rams and alarms to decide where to send the water, and every one of these components can fail. Debris in the valve is the most common problem, closely followed by a valve that gets stuck halfway between the two outlets.

DIVERSION VALVE SERVICES

Routine Servicing

Diversion valves need regular servicing to make sure they switch between stormwater and trade waste when they’re supposed to. We clean out the valve chamber, remove silt and debris, and check the moving parts and operating components for signs of wear or damage.

We service commonly installed systems in New Zealand, including Hynds Enviro-Valve and Stormwater360 FOX systems. The work depends on the valve type and manufacturer’s maintenance requirements.

Fault finding & repairs

Valve not switching? Stuck halfway? Getting an alarm when everything looks fine? These problems can be caused by debris, blocked control lines, faulty sensors, actuators or worn valve components.

We work through the system to find what’s causing the problem and carry out repairs where required. We can also look at related equipment, including flow switches, control panels, alarms, oil and grit chambers and holding tanks.

System testing & performance checks

A diversion valve needs to operate correctly to make sure water is directed to the right place at the right time. If it isn’t working properly, contaminated wash water could end up in the stormwater system or clean rainwater could be sent to the sewer.

We can test the valve and its controls to make sure everything is working as it should, and identify any servicing or repairs needed

Give us a call with the make and model of your valve and we can talk through what’s required.

“Our diversion valve was a small part of a much bigger project, but it needed to be right before anything else could move ahead. The crew at Enviro water understood all that and got our work sorted. Good communication, and everyone knew what was happening.”
Felipe Graves, Waikato